Environmental Measurement Research Corporation
Physical Specifications
Size: EMRC will package to fit the needs of its customers
Weight: Stationary @ 100 - 250 lbs.
Power: 115v, 60hz Operating Cabinet
Temperature: 30° - 120°F (Some units have internal heaters)
Probe Temperature: -2000° F (melting point of probe material) or ceramics up to ~3000° F
Recorder Outputs: 4-20 ma standard, all others upon request
Performance Specifications Sensitivity: ~2fps
Response Time: ~1-2 seconds to 100% of final reading
Linearity: +/- 2% of full scale
Repeatability: < 1 % Zero Drift: ~2% of full scale Span Drift: ~2% of full scale
Accuracy: ~2% of full scale
The EMRC Gas Flow Monitor is the most reliable system available.
- +99.99% uptime
- Low installation cost
- Low maintenance cost
- No utilities at the stack or duct
(probe can operate in explosion hazard situations)
- Fully automated calibration and purge
- Onboard primary reference manual calibration capacity (no need to go back to the factory)
- In situ sensors are designed to meet extremely hostile conditions
(corrosion,high temperatures, moisture, etc.)
- EMRC personnel are available to supply a stationary or portable unit and electronic interfacing system so that mass flow requirements can be met on a consistent and verifiable basis.
- All EMRC Gas Flow Monitors are custom-designed to match each gas flow stream condition. We can custom design employing site-standard electronic components. We will build to your standard component desires.
{Copyright (C) 2010 EMRC, Inc. All Rights Reserved}